Each Mannequin comes with a screwdriver, which is used to adjust the ball joints. The joints should never be forced and only tightened enough to hold a position. On the shoulders of the Mannequins you will find a brass screw, which is used to tighten the upper arm joint to allow the arms to be held out if required.
The stand is adjustable for height and the best way to get your Mannequin in the desired position is to start with the stand a couple of inches higher than the legs, drop the Mannequin on to the stand, put the legs in position and then lower to the ground. The stand should be positioned with the two loops to the front.
| < Prev |
|---|
